SolidBond / goot Solder Suction Wire CP-2515

This solder wick is made of copper wire coated with a special flux. It heats up and instantly sucks up molten solder, removing excess solder. It's ideal for removing old solder from circuit boards, pots, jacks, and pickup replacements, as well as for removing solder from delicate areas that are difficult to remove with a solder wick, such as around surface-mounted devices (SMDs) and multi-pin ICs. It's 2.5mm wide and 1.5m long.

[RMA-compliant flux included as standard]
- A special non-chlorine flux is impregnated into the braided copper wire for efficient solder removal. Ideal for precision electronics, SMD component removal, and solder short repair.

[Lead-free solder wick]
- For lead-free solder removal. The thin and soft wick conforms to the circuit board and transfers heat efficiently.
- High thermal response allows for faster solder removal compared to conventional products, making it recommended for lead-free solder, which requires high thermal loads.

■Solder wick
■Width: Approx. 2.5 mm
■Length: Approx. 1.5 mm
■Non-chlorine (RMA) compliant flux
■Lead-free solder compatible
■Comes in an ESD-safe case
■Static-protected