Walrus Audio / Melee: Wall of Noise

Melee is a distortion/reverb combo pedal that creates a huge "wall of noise" by using three different reverb programs, a switch to switch the connection order between distortion and reverb, and joystick controls for each effect. The distortion and reverb combo pedal creates a "wall of noise" of sound.

■Reverb Programs
Three different reverb programs are provided.
The program is changed by pressing the bypass and sustain switches simultaneously.

・Ambient Reverb
A reverb capable of huge trails. Ideal for soaring melody lines and shoegaze.
Octave Down Reverb
It's a nice, dark, eerie sound with an octave down, like Walrus Audio's "Slo" Dark mode.
Reverse Reverb with Feedback
This mode adds a reverse reverb to the original sound, perfect for sad, slow chord playing or huge reverse feedback.

MOMENTARY
Hold the Bypass switch while bypassing to turn on the effect for as long as you hold it down; release the Bypass switch to turn it off, and the effect will fade out.
While holding the Sustain switch, the reverb trail crescendos. Release the Bypass switch to decrescendo the reverb trail.
If you press and immediately release the Sustain switch, the ringing reverb decay will continue to play. Press the switch again to release it.

■JOYSTICK
Use the joystick to mix distortion and reverb. Left and right set the amount of reverb, and up and down set the amount of distortion.
The full left is 100% dry, the full right is 100% wet, the full down is completely clean, and the full up is maximum distortion.

D>R | R>D
Swaps the connection order of the distortion and reverb, greatly changing the effect.
D>R" uses the conventional pedalboard connection order for a clear sound. R>D" creates a wall of sound that melds single notes and chords together.
In addition, the behavior with the joystick is slightly different.

Power supply: 9VDC center-minus (adapter only) 200mA minimum
Size：10cm(W)×11.8(H)×8(D)cm
Weight: 394g