DSM & Humboldt Simplifier / SIMPLIFIER BASS STATION

Equipped with a preamp stage based on Ampeg SVT, flexible EQ of +-15dB per band and switchable midrange from 400-900-1500Hz allows for a wide range of sound creation.

■Bass Effects ■Preamp/DI ■Amp Simulator ・Blend Section After the preamp, the signal from the parallel signal chain (which bypasses the preamp and has its own Fx loop) can be blended back into the main signal. You can also get different textures and low end response by blending in the Cabinet Simulation. ・Preamp Blend Blends the preamp signal and the parallel signal into the main signal. Set this control to 100% then blend the parallel signal until you get your desired mix. ・Cabsim Blend Blends the Cabsim into the main signal. ・Parallel LPF 3-way toggle switch to enable a 2-pole LPF that affects the parallel signal. 100Hz: Deep low end is preserved and harmonics are filtered. OFF: LPF is disabled. 500Hz: Deep low end is preserved and low mids are preserved in the parallel signal chain. ・Cabsim MIC POSITION: By adjusting the microphone position you can precisely adjust the high end roll-off. Cab Size Switch 4x10 Vented: A modern standard with flat low-end response and a bright, driven sound. 8x10 Sealed: A huge-sounding low-end cabinet equipped with modern speakers. 1x15 Vented: A warm, rounded cabinet with an extended low end and a creamier, more subdued sound in the high range. Speaker Color Switch Bright: An aluminum cone speaker with good sound projection. Modern: A flat response with a wide range of highs and lows. A so-called "boomy" sound. Warm: A vintage speaker with a clear mid-response and smooth highs. ■Technical Specs
・Current consumption: 50mA to 100mA (if Headphone out is used)
・Supply voltage: 9V - 12V
・Polarity: Center negative
・Input impedance: 1 Meg Ohm
・TRS output impedance: 100 Ohm
・DI Output impedance: 120 Ohm
・Send output impedance 100 Ohm
・Return Input Impedance: 1 Meg ohm
・Headphone Power: 120mW @ 32 Ohm


■Size
Width: 115mm
Height: 65mm
Depth: 55mm
Weight: 430g