■ For iPhone/iPod Touch/iPad
* Please refer to iRig Acoustic Stage
for models with preamplifiers.
A brand new mobile microphone/interface that allows you to record sounds comparable to studio recordings with high-end mics by simply clipping them into the sound hole of your acoustic guitar or ukulele. The state-of-the-art MEMS microphone is adopted, and the sound of a guitar and a ukulele full of rich presence is realized.
It was designed to pick up expressive acoustic guitar sounds that would not have been possible without the help of a seasoned recording engineer. Equipped with a state-of-the-art omnidirectional MEMS microphone, iRig Acoustic can be attached to the sound hole of an acoustic guitar or ukulele with a clip that supports up to 4 mm thick, and can pick up sound in a wide frequency range of 15 Hz to 20 kHz. Is possible. From the complex overtones unique to acoustic instruments to the resonance between the strings and the body, you can capture everything.
The state-of-the-art MEMS (Micro Electrical-Mechanical System) technology (=mechanical operation/structural elements are minute, instead of the piezo and magnetic pickups that are often used when connecting acoustic guitars and ukuleles to lines. Microphones with state-of-the-art technology that accumulates on microchips) are used. By installing an omnidirectional MEMS microphone with a small but accurate and flat frequency characteristic in the sound hole, it was difficult to capture with a pickup that only picks up the vibration of the strings and the vibration of the body so far. It is possible to pick up the guitar sound with a strong presence. iRig Acoustic's clip, which supports up to 4mm thickness, uses a soft rubber material that can be easily attached and detached without worrying about damaging your important instrument.
For audio input/output, the 4-pole mini terminal (1/8” TRRS) that is familiar with the earphone/microphone attached to the iPhone is adopted. Compatible with iPhone, iPad, and iPod touch. iRig Acoustic's stereo mini. The headphone output jack can be connected not only to earphones and headphones, but also to IK's portable studio monitor speaker iLoud, live PA mixer, and so on.
Microphone type: MEMS
Connection terminal: 1/8 inch TRRS headphone/microphone shared terminal
Cable length: 200 cm