FULLTONE / SUPA-TREM2 V2

A while ago I started wondering what would happen if I put two completely separate Supa-Trem circuits together! Rather than fake stereo like other tremolo, chorus, phase, and flanger pedals, these simply invert the signal at the output and send it to a separate jack.

CS-ST2 v2 is TRUE-STEREO with 2 INs and 2 OUTs and has 2 identical independent circuits! Bypass is enhanced by high quality JFET buffer output. The CS-ST2 v2 works as an amplifier splitter, allowing you to run as many cables as you like.
■Control
・VOLUME: Adjust the volume.
・MIX: Adjust the ratio of input signal and tremolo signal. Turn the MIX knob fully counterclockwise to use it as a clean boost pedal.
・RATE: Controls the tremolo speed. Changing the RATE knob will cancel the speed setting made by the TAPTEMPO switch.
・PHASE CORRELATION: You can freely adjust the relative phase between the two tremolo circuits.
・SQUARE/SINE/WARBLE: You can select the waveform.
・TAP TEMPO Footswitch: You can set the tremolo speed by tapping two beats of the desired tempo.
・ON/OFF Footswitch: Switch to turn on/off.

■MONO (R) INPUT: 1/4” monaural standard phone input terminal. Stereo output is possible even when monaural input is used.
■(L) INPUT: 1/4"" monaural standard phone input terminal. By connecting this unit after another effect that has a stereo output, you can maintain stereo sound regardless of whether the pedal is ON or OFF.
■MONO (R) OUTPUT: 1/4” monaural standard phone output terminal
■MONO (L) OUTPUT: 1/4” monaural standard phone output terminal Used when connecting to other effects with stereo input, or when connecting stereo to an amplifier.
■EXT.TAP INPUT: Connect when using the tap tempo function from an external switch using a 1/4” monaural standard phone cable. Only compatible with SPST momentary non-latching switch.
■DC INPUT: Operates from a high quality regulated 2.1mm x 5.5mm plug 9-18VDC center negative power supply.