FULLTONE / PLIMSOUL MKII

PlimSoul is the only pedal that offers separate control for soft and hard clipping. PlimSoul's unique, independent, dual-stage clipping circuit was designed to recreate not just the sound, but the subtle and complex feel of a tube amp.

The PlimSoul mkII has increased its input impedance from 500k to 1.1 megohms for even better interaction with your guitar's Volume knob. In addition, soft clipping (Stage 1) and hard clipping (Stage 2) are now completely independent, allowing you to turn up the Hard Clipping knob for aggressive, punchy gain while turning down the Soft Clipping knob. Additionally, for hard clipping, two germanium diodes connected to Vref are used instead of LEDs. The Soft-Clipping stage is highly asymmetrical and the Hard-Clipping stage is symmetrical, allowing you to dial in endless combinations of the two. It also features a top-mount jack and external power port, and is designed with ease of use inside the board.

■Control
・Volume: Adjust the volume.
・SOFT-CLIP: Controls the amount of soft clipping (overdrive). Turning clockwise increases overdrive.
・HARD-CLIP: Controls the amount of hard clipping (distortion). Turning it clockwise increases the distortion. Note: This knob makes a slight rubbing noise, but this is not a product defect as the JFET bias is changing for gain makeup.
・MIN/HALF/MAX Switch: This lossless bass control is located just before the hard clipping stage. ""Min"" is the minimum amount of bass, ""Half"" is approximately double the amount, and ""Max"" is the maximum amount.
・TREBLE: Turn counterclockwise to reduce the amount of treble. Since it is affected by the soft clipping and hard clipping settings, please adjust the balance in conjunction with each control.
・ON/OFF Footswitch: Switch to turn on/off.

■INPUT: 1/4” monaural standard phone input terminal
■OUTPUT: 1/4” monaural standard phone output terminal
■DC INPUT: Operates from a high quality regulated 2.1mm x 5.5mm plug 9-18VDC center negative power supply.
■BATTERY: It can also be powered by a 9 volt battery (006P battery). To replace the battery, unscrew the screws on the left and right sides of the housing, separate the top and bottom of the pedal, and replace the battery.