RJM / RJM MICRO LINE MIXER

The RJM MICRO LINE MIXER is a significant update of the potential of the original LINE MIXER, combining four inputs and outputs with MONO/STEREO inputs and outputs and DRY and WET LEVEL adjustment in a compact size. It is a stereo line mixer.

It is possible to mix a dry signal from a guitar amp send or line out with a wet signal from up to three spatial effects devices (Reverb, Delay, etc.). The compact, high-quality MICRO LINE MIXER can be used for parallel mixing as well as for building a 'Wet / Dry / Wet Effect System'.

Features.
Equipped with a DRY INPUT that passes through a high-quality RJM BUFFER circuit.
Up to three effectors can be connected in MONO or STEREO [*1].
The signal input to the DRY IN can be split internally and output from the BUFFER OUT [*2].
The signal from the MIX OUT can be output in MONO or STEREO [*3].
Levels can be adjusted individually using the DRY LEVEL and WET LEVEL knobs.
Input/output can be changed to MONO or STEREO by changing the internal jumper wiring for DRY IN and BUFFER OUT.

[*1] The effector to be connected must be set to Kill Dry mode (Mix 100%).
[*2] When connecting to two or more effectors, a Y cable or passive splitter is required separately.
[3] Use a Y cable for the STEREO OUT.

Specifications.
Dry Input: 1MΩ input impedance
Wet Inputs: 100kΩ input impedance
Outputs: 150Ω output impedance
Level Controls: -∞ to unity gain
Frequency Response: 20Hz-20kHz
Headroom: +9dBV using 9V power supply, more with higher voltage power supplies
Power Requirements: 9-24V DC (centre negative polarity), 50mA minimum
BOSS-type power connector, 5.5mm/2.1mm barrel connector
Dimensions: 11.20 (w) x 6.05 (d) x 4.19 (h) cm
Weight: 227g
Made in USA