MOOER / TENDER OCTAVER X2

The Mooer TENDER OCTAVER X2 is an octave pedal in a compact pedal size. It adds accurate upper and lower octave sounds, and the balance between the dry signal and upper and lower octaves can be adjusted individually. In addition, these settings can be saved as 14 presets.

■October
■Adapter: 9V center-minus
■Battery powered: -
■Controls: SUB, UPPER, S.TONE, U.TONE, DIRECT, SAVE

■Features
Accurate octave pedal
Complete upper and lower octave coverage
Independent upper and lower octave tone controls
14 preset slots
Two footswitches allow separate control of upper and lower octaves or selection of presets

■Controls
SUB: Adjusts the volume of the sound in the lower octave.
UPPER: Adjusts the volume of the sound above the octave.
S.TONE: Adjusts the volume of the sound below the octave.
U.TONE: Adjusts the tone above the octave.
DIRECT: Adjusts the volume of the original sound.
SAVE: Press to scroll through the 14 preset slots. Press and hold to save the current setting to the selected preset slot.
SUB footswitch: Toggles the effect ON/OFF in the lower octave.
UPPER footswitch: Toggles the effect ON/OFF for the upper octave.


Input/Output
INPUT : 1/4” monaural audio jack. Connect the cable from the instrument side.
OUTPUT : 1/4” monaural audio jack. Connect the cable from the amplifier.
DC IN: Connect an adapter of 9 VDC (center minus) and 300 mA or more. Use of the supplied adapter is recommended.

■How to use
Selecting Preset Slots
The Tender Octaver X2 has 14 preset slots: 7 red slots and 7 blue slots, which can be selected in the following ways
1. Scroll through the slots with the SAVE button.
2. Press the left and right footswitches simultaneously to enter the preset select mode. Scroll up the preset with the left footswitch and → scroll down with the footswitch. This mode will automatically exit after 3 seconds.

Turn on/off the effect module.
The Tender Octaver X2 has two effect modules, SUB and UPPER, which can be individually turned on and off with the SUB and UPPER footswitches, respectively.

Adjusting effects
Turn the DIRECT knob to adjust the volume of the original sound when the effect is on. At the maximum position (5 o'clock), the volume is the same as the input signal. At the minimum (7 o'clock) position, the original sound is turned off.

Turn the SUB and UPPER knobs to adjust the volume down an octave or up an octave. At the maximum (5 o'clock) position, each octave is the same volume as the input signal. At the minimum (7 o'clock) position, each octave is turned off.

S.TONE and U.TONE are used to adjust the tone below the octave and above the octave.

■Saving Effect Parameters
When an effect parameter is changed, the LED blinks to indicate that it has been changed from the saved contents. pressing and holding SAVE will overwrite the current settings and save them. If you switch presets without saving, the changes will be discarded.

■Setting the Output Mode
The Harmony X2 has two output modes: Mix mode and Individual mode.
The color of the SAVE button LED indicates the current mode: Mix mode is red, Individual mode is blue.

■Factory Reset
Pedal adapter.