Darkglass Electronics / MICROX900

A bass amp head designed after the Darkglass Electronics X-series pedals. Equipped with a Class D 900W amp, EQ, and X-Distortion. You can create a tone to suit any need.

[直輸入品][Direct Import]

■Bass amp head
■Output: 900W RMS(4Ω) / 450W RMS(8Ω)
■Control: MASTER, HPF, DRIVE, MIX
■MICROTUBES ENGINE (VMT or B3K): DRIVE, LEVEL, TONE, BLEND
■X ENGINE: LEP, OCMP, LEVEL
■EQ: 250Hz - 3kHz
■Passive/active switch
■CLEAN COMP switch
■Mute switch
■USB
■I/O: Input, power amp input, preamp out, speaker out, foot switch, balance out (XLR), headphone out
■Accessories: Foot switch, power cable
■Size: 230x270x70mm
■Weight: 2.9kg

HPF: Controls the cutoff frequency of the high-pass filter applied before the signal is sent to the distortion circuit. It can be set arbitrarily from 100 Hz (fuzz-like saturation sound) to 1 kHz (sound with very sharp contours).

LPF (Low Pass Filter): Controls the cutoff frequency of the low pass filter applied before the signal is sent to the compression circuit. It can be set arbitrarily from 50 Hz (sub-bass only sound) to 500 Hz (sound that retains a clean midrange).

*Warning
- Do not disassemble the amplifier.
- Do not use the amplifier in humid environments or near liquids.
・Microtubes X 900 can reproduce volumes over 115dB. This level of volume can cause serious damage to your hearing. Please use with appropriate hearing protection.
- Microtubes X 900 has an output of over 900W RMS into a 4 Ω load. Please use a suitable speaker cabinet that can withstand the output of this amplifier.
・Please be careful not to block the ventilation holes. Fans and vents are part of the amplifier's cooling system. Blocking the vents can cause the amplifier to overheat and be damaged.
- Do not use shielded cables for musical instruments in place of speaker cables. Shielded musical instrument cables are not designed to carry output signals from amplifiers to speakers.