FLAME / QSlider

4 slider controlled CV source. Knob range can be set from 0 to +10/-5 to +5.

The QSLIDER is an analog CV source with four 60mm faders. The control range of the four sliders can be set with two Min/Max knobs. The Min knob sets the output voltage when the slider is moved to the bottom, and the Max knob sets the output voltage when the slider is moved to the top. The slider moves between these two voltage settings. This allows you to use the full range of the slider while limiting the output voltage range.

The inverted voltage is output from the second INVERSE OUT (the min and max values ​​are swapped). This allows the sliders to be used as cross-mix faders. Channels 1 and 2, and channels 3 and 4 can each be set to operate unipolar or bipolar with a common switch. The voltage range that can be set is 0 to +10V (unipolar) or +/- 5V (bipolar).

QSLIDER consists of two modules: the QSLIDER main unit and the output module QSL-OUT. Neither module works alone. These are connected to the dedicated bus on the back of the main unit with a bus cable. You can mount the QSLIDER main unit in an easily accessible location and the QSL-OUT in any remote location.

Width: 18 + 4HP
Depth: 28mm
Current consumption:
+12V: 42mA
-12V: 40mA
+5V: 10mA
Notes: Use a combination of two modules, QSLIDER and QSL-OUT. Neither module works alone.