Gamechanger Audio / GCPLASMARACK

A unique rack-type overdrive that produces distortion using a high-voltage plasma circuit. Equipped with numerous tone controls and input/output jacks, it can be used for a wide range of purposes.

■Guitar Effects
■Overdrive/Distortion
■Rack Type
■3-Band EQ
Adds more control to key plasma frequencies.
(10Hz, -20 to 20 dB LP Shelving Filter; 600Hz, -6 to 6 dB; 20kHz, -10 to 10 dB HP Shelving filter)

■Input Gain Control
Fine-tune for connecting any type of instrument or equipment (adjusting the volume difference between different pickups, etc.)
(Preamp Gain Range: -26dB to +12dB)

■Sustain Mode
Built-in adaptive compressor that extends the output of the plasma tube at low voltage settings.
This creates a completely unpredictable and unusual sputtering sound.

■Oversaturate mode
Analog octave up/harmonic addition obtained by overpowering the plasma tube
This adds intense ""Octavia-style"" upper harmonics to the attack and makes the whole sound more intense. /p>

■Clean gate mode
Used when you want to get the plasma tube gate effect on a clean signal without adding distortion
Perfect for any percussive instrument, you can use the discharge gap to chop up heavy reverbs or get a bit crusher-like effect.

■Plasma tremolo/ring modulation
A very unusual tremolo circuit that makes the most of the sputter and sudden bursts of the plasma tube. Not only can it be used for slow tremolo, but it can also be transformed into screaming ring modulation by setting it to the maximum.
In addition, it also has a dynamic tremolo mode that applies the tremolo (or ring modulation) effect only on the attack or decay.

■Built-in distortion channel
Plasma distortion matches very well with classic op-amp distortion. PLASMA RACK can instantly create a huge range of sounds using the built-in distortion circuit.
The CLEAN GATE button adds a tube gate effect to the distortion channel.

■3 FX loops, switchable level control
The FX loop allows you to insert external effects at various points in the PLASMA RACK signal chain.

FX LOOP 1: Insert external FX only on the dry signal
FX LOOP 2: Insert external FX only on the wet signal, insert point is before the plasma tube
FX LOOP 3: Insert external FX only on the wet signal, insert point is after the plasma tube

■Connection terminals
Input: 1 unbalanced 1/4"" TS jack input (Instrument), 1 balanced combo XLR/jack input (with pad)
Output: 1 balanced XLR, 1 unbalanced 1/4"" TS jack
MIDI: Input, Thru, Output

■Full MIDI control + 8 preset slots
All parameters and values support MIDI CC (control change) and program change
Eight preset slots are provided, allowing you to save button states and knob values
In addition, you can control multiple PLASMA RACKs via MIDI Can be synchronized using CC

■Assignable expression input

Volume, blend, voltage, tremolo depth, rate, and other knobs can be controlled with an expression pedal

■Utility settings can be saved

By setting the default state of all buttons, knobs, functions, etc., PLASMA RACK can be used immediately anytime, anywhere

■Size: 440mm (W) x 255mm (D) x 40mm (H)
■Weight: 4.1kg