Shift Line / EVEREST

Everest is a pedal that can apply the excellently compatible effects of delay and reverb in parallel. It has three different characters, allowing you to create a wide range of sounds.

■Guitar Effects
■Delay/Reverb
■Features
- 9 types of sounds with reverb and delay that can be set individually and in parallel (3 modes each for delay, reverb, and delay + reverb)
- Maximum delay time is 850ms, delay and reverb can self-oscillate
- All analog dry through
- Adjust the volume of the wet signal with the MIX knob
- Tails can be switched ON/OFF by pressing the foot switch 10 times within 10 seconds of turning on the power. The LED flashes quickly when Tails is OFF and slowly when it is ON.
- Buffered bypass
■3 Modes
- Sunshine mode (lower position)
　　 Bright and clear tone.
　　 Features a cold and clear delay sound like a sunny day on the top of Mt. Everest.
　　 You can also make the reverb self-oscillate and cause an avalanche.
　　 In this mode, the delay repeats are not filtered and the reverb has no phase distortion.
・Eclipse mode (middle position)

Dark tone.

The sun goes down, the snow sparkles, and the mountain peaks sink beautifully into darkness.

Modulation delay and sublime reverb create the atmosphere.

In this mode, a 6db/Oct filter is applied to the delay, phase distortion is applied to the reverb, and the top end is rolled off.

・Moonshine mode (upper position)

Psychedelic mode. A tone that touches the mysteries of the Himalayas and impresses you with the nature of Everest.

An octave is added to the delay repeats and reverb, creating a tone that seems to jump between dimensions.

In this mode, an octave above is added to the filtered delay repeats.

No filtering is applied to the dry signal. High frequencies are naturally cut and the volume is slightly reduced.

An octave below is also mixed into the reverb.
■Controls
-REVERB: Adjusts the volume of the reverb. Turning counterclockwise to the minimum will turn off the reverb.
-MIX: Adjusts the volume of the wet signal. Does not affect the dry signal.
-REGEN: Adjusts the delay feedback and reverb length.
-TIME: Adjusts the delay time. Also slightly affects the reverb decay. Turning counterclockwise to the minimum will turn off the delay.
-MODE: Switches between three modes: Sunshine, Eclipse, and Moonshine.
■Power supply: Standard center negative DC9V adapter or 9V battery
■Current consumption: 70mA
■Dimensions: 111 x 60 x 50 mm