Amptweaker / PressuRizer

A compressor that has minimal effect on the attack, giving you sustain without the typical compressor sound.

Sustain without compression.
Let's consider this problem that many players want.
You can extend sustain by applying a compressor, but many compressors change the attack of the sound. If the attack changes, the overall atmosphere of the sound will be completely different.
So Amptweaker has developed a compressor that does not interfere with the attack.
The Amptweaker PressuRizer uses a unique method to extend sustain without sacrificing the attack of your guitar or bass. It also has a built-in FET booster/limiter, so it can be used as a boost pedal. In other words, PressuRizer gives you a powerful clean tone.
Equipped with a studio-grade compressor with dry/wet blend control and a sidechain mechanism unique to PressuRizer. Not only can it be used as a smooth compressor that applies compression from the attack to the entire tone, but it can also be used as a natural compressor that delays the compression and leaves the attack intact. It is also designed to provide the best compression for both guitar and bass.

The Bloom switch (Fast/Off/Slow) allows you to set the sidechain tone detection mechanism and switch the onset of compression. By combining it with a dry blend, you can get a long sustain without changing the attack of the sound.
The Tone control only affects the compressed sound, and you can balance the dry blend by emphasizing the top end or suppressing the midrange.
The Limit switch adds a FET booster/limiter after the dry blend. In Soft mode, a light limiter can be applied, and in Hard mode, a sense of saturation is added to the tone. You can disable the limiter by turning it off. This FET limiter has vacuum tube-like characteristics and creates an output. The gain level of the booster/limiter can be adjusted with the OUTPUT LEVEL trim pot inside.

The PressuRizer's foot switch also has two functions. Normally it works as a true bypass switch, but by pressing and holding it, the compressor is always on and it can be used as an ON/OFF switch for the booster. At this time, you can adjust the boost level with the Boost knob on the side. This compact pedal offers a wider range of operability. The footswitch mode is saved even when the power is turned off.

●Features
・Control the compressor with the Sustain, Tone, and Volume knobs
・Tone control that can emphasize the top or cut the mids
・Bloom switch that allows you to switch the start of compression
・Wet/dry blend without sacrificing the attack of the tone
・FET output booster/limiter with three settings and fine adjustments
・Boost can be turned ON/OFF by pressing and holding the footswitch
・True bypass switch
・Powered by a center negative DC9-18V adapter
・18V achieves a more open sound
・Can also be powered by a 9V battery
・Back panel can be removed with one thumb screw

●Specifications
Input Input impedance: 250kΩ (effect ON)
Output impedance: up to 10KΩ (effect ON)
Current consumption: 24mA (9V), 30mA (18V)
Adapter: 5.5mm x 2.1mm center negative DC9V to DC18V
Housing: Made of 2mm thick aluminum, it is both durable and lightweight
Weight: 283g
Size: 6.8cm (W) x 11.8cm (D) x 5.0cm (H)
Type: Compressor (for guitar and bass)
Adapter: 9 to 18V center negative
Battery powered: 9V battery
Controls: Volume, Tone, Sustain, Blend, Boost, Limit switch, Bloom switch, OUTPUT GAIN trim pot