Sophia Tremolos / 2:22 Deluxe Tremolo Pro Chrome

Sophia Tremolos 2:22 Deluxe Tremolo Pro is the most standard and high-end modern tremolo unit for multiscale.

It can be directly replaced with a standard two-point synchronized tremolo. The stainless steel locking saddle allows strings to be attached with the ball ends attached, and the unique design transmits string vibration firmly.
The Pro model features global tuners with built-in dual stabilizers for even greater stability and easy adjustment of the floating position.

●Features
- Supports multi-scale intonation differences of up to approximately 20° [0.675+] between the 1st and 6th strings. *If the multiscale exceeds 16°, it is necessary to remove the spring block on the bass string side.
- Sleek, low-profile cast stainless steel saddle
- 2.11 (53.59 mm) 6-string space/0.422” (10.7 mm) string spacing
- 25.25” from nut to centerline of riser post (scale)

●Accessories
1× Special arm with no wobble
2× riser posts (inserts included to adjust stud hole depth)
4 x copper-coated springs
1 x Copper coated spring claw
1×2mm adjustment wrench
1×3mm riser post installation wrench
1×1.5mm wrench
2 x GT Pro-specific acoustic damping felt pads (Pro model)


●Installation
- Install the riser post on the studs. If the stud is too deep, insert the insert screw first to adjust the stud depth.
- Adjust the dual stabilizer pins with the thumbwheel to align with the body.
- Lock the adjusted setup with the coupling lock. If the springs are also to be adjusted, lock them after all adjustments are completed.
- Adjust the spring claw screws to balance.

●Structure
- Tremolo unit
The Pro model can be easily fine-tuned to the tremolo stop position using the thumbwheel. Pro models are equipped with dual stabilizers. models manufactured after 2022 no longer have a contact pin at the end of the stabilizer for adjustment, but this does not make a difference in performance. Models manufactured after 2022 no longer have the contact pin at the end of the stabilizer for adjustment, but there is no difference in performance.

*The truss rod may need to be adjusted when the tremolo is first installed.

- Deluxe Saddle
The Deluxe saddle is a locking bridge saddle. The strings can be changed by the following method.
- Use the supplied 2mm hex wrench to turn the locking screw to loosen the lock.
- Insert the string until the ball end is seated in the port. If the string is thicker than .050, pass it through the nose slot and under the clamp.
- Lock the string with a 2mm hex wrench.
- When adjusting intonation, insert a 2 mm hex wrench into the intonation adjustment hole and adjust the intonation.

*When removing the strings, do it the other way around.