Sophia Tremolos / 2:22 Deluxe Tremolo Chrome

The Sophia Tremolos 2:22 Deluxe Tremolo is the most standard and high-end modern tremolo unit for multiscale.

It can be directly replaced with a standard two-point synchronized tremolo. The stainless steel locking saddle allows the strings to be attached with the ball ends on, and the unique design transmits the string vibration firmly.
A brass tremolo block with tremolo stop is mounted.

●Features
- Supports up to approximately 20° [0.675+] multi-scale intonation difference between the 1st and 6th strings. *If the multiscale exceeds 16°, the spring block on the bass string side must be removed.
- Smooth, low-profile cast stainless steel saddle.
- 2.11 (53.59 mm) 6-string space/0.422” (10.7 mm) string spacing
- 25.25” from nut to centerline of riser post (scale)

●Accessories
1× Special arm with no wobble
2× riser posts (inserts included to adjust stud hole depth)
4 x copper-coated springs
1 x Copper coated spring claw
1×2mm adjustment wrench
1×3mm riser post installation wrench
1×1.5mm wrench

●Installation
Install the riser post on the studs, place the tremolo unit in the cavity, install the spring claw in the cavity on the back and secure it with the spring. If necessary, the tremolo stop can be adjusted to fix the tremolo return position.
If the studs are too deep, insert the insert screws first to adjust the stud depth.

●Structure
- Tremolo unit
A special tremolo block is provided to adjust the tremolo stop. The tremolo stop can be fixed firmly with coupling screws after adjustment. Once the tremolo stop is fixed at the zero point position, the tremolo always returns to the zero point position, although the arm is only down, so tuning can be stabilized.
For bolt-on neck guitars, adjust the base plate at 90° to the riser post, and for set neck guitars, adjust according to the neck angle.

- Deluxe Saddle
The Deluxe saddle is a locking bridge saddle. The strings can be changed by the following method.
- Use the supplied 2mm hex wrench to turn the locking screw to loosen the lock.
- Insert the string until the ball end is seated in the port. If the string is thicker than .050, pass it through the nose slot and under the clamp.
- Lock the string with a 2mm hex wrench.
- When adjusting intonation, insert a 2 mm hex wrench into the intonation adjustment hole and adjust the intonation.

When removing the strings, do it the other way around.