FLAME / 4. Vox

4 VCO wavetables capable of playing up to 16 voices. MIDI compatible.

4VOX QUAD POLYPHONIC WAVETABLE OSCILLATOR is a polyphonic wavetable oscillator with 4 VCOs. Up to 4 voices can be used per VCO channel, and up to 16 voices in total can be output from 4 individual outputs. It can be played with MIDI or CV, and additional parameters can be controlled with MIDI. There are 39 memory areas to store wavetables, and 32 patches to store all global and VCO parameters.

Wavetable parameters can be controlled with CV and MIDI. Wavetables can be morphed using CV from other modules, MIDI controllers, or knobs on the control panel. The maximum and minimum values ​​of the range of the waveforms in the wavetable can be set independently for each voice, allowing for more complex morphing.

Controllable parameters are Detune, Semitone, Octave, Chord, Portamento, Amplitude and Amp Move (changes the volume modulation of the 4 voices of the VCO by 90 degrees in phase). These parameters can also be set to maximum and minimum values. These parameters (notes, chords, pitch bend, patch selection and wavetable selection) can be controlled via MIDI.

The VCO can be played monophonically using analog control via the Pitch CV In or controlled via MIDI, or 4-voice polyphonic using MIDI.

The VCO can also be used as a VC LFO, with three modes to choose from: LOOP, ONE SHOT and GATED. The SYNC input acts as a trigger/reset for the LFO. In ONE SHOT mode the LFO can also be used as a trigger delay (SYNC = trigger in, GATE = trigger output, PITCH = delay time).

Each VCO has a 1V/Oct CV input, allowing fine tuning (+-1 semitone) and pitch control (approximately 10 octaves). Two freely assignable CV inputs with two knobs: a trigger input for oscillator sync/LFO reset, a GATE output and a VCO/LFO output.

All global parameters and VCO settings can be named and saved up to 32 patches can be saved. The display shows the selected waveform.

Width: 29HP
Depth: 50mm
Current consumption:
+12V: 180mA
-12V: 50mA