TOA / WM-D1510

This digital wireless microphone mixer complies with the regulations for specific low-power radio station radio microphones (800MHz band). It has four inputs and can mix and transmit audio from microphones, portable musical instruments, PCs, etc. Any one of the 30 waves assigned to Type B can be selected, and it uses a digital transmission method that is resistant to interference and crosstalk.

A digital wireless microphone mixer that complies with the standards for specific low-power radio station radio microphones (800MHz band). It has four input systems, allowing you to mix and transmit audio from wired microphones, portable musical instruments, PCs, etc. Any one of the 30 B-type waves can be selected, and it uses a digital transmission method that is resistant to interference and crosstalk. Furthermore, not only does it achieve high confidentiality (security setting function) through its unique information concealment technology, but it also supports a wide range of usage conditions, such as the use of the same channel between nearby areas by switching the code setting function and transmission output, and the expansion of simultaneously used channels by switching between 10ch/15ch modes. Power supply: AC100 V 50/60 Hz: Uses AC adapter (included) (DC4.5V) DC3V: Uses two AA alkaline batteries (LR6) Dual power supply method Current consumption: 170 mA (when using AC adapter/batteries) Radio wave type: F1E/F1D Transmission frequency: 806.125-809.750MHz (1 of 30 waves) Oscillation method: Crystal-controlled PLL synthesizer method Modulation method: FSK method Rated antenna power: 1 mW (transmitting power: L)/6 mW (transmitting power: H) Reach distance: Under good outdoor conditions Approximately 60 m: 1 mW (transmitting power: L) Approximately 100 m: 6 mW (transmitting power: H) *When receiving side ATT is 0 dB Occupied frequency bandwidth: 165 kHz or less (10ch mode)/145 kHz or less (15ch mode) Maximum input sound pressure: 110 dB SPL (volume at maximum) 120 dB SPL (volume at 7 scale) Input equivalent noise: 43 dB SPL or less (using A-curve) Input: Microphone: -54 dB (*1) 2 kΩ unbalanced φ6.3 horn jack (2P) (input 1-4) Line: -16 dB (*1) 10 kΩ unbalanced φ3.5 mini jack (3P: stereo) (L+R mono, input 3, 4 switchable) Built-in microphone (switchable): -46 dB (*1) 600 Ω unbalanced φ3.5 mini jack (2P) (input 1 switchable) *The rated input level is the input level at which the volume is at maximum and the input sound pressure is 94 dB SPL. Recording output: 0 dB (*1) 1kΩ Unbalanced φ3.5 mini jack (3P: stereo) (L+R mono) Built-in microphone: Unidirectional electret condenser type Frequency response: Mic: 150Hz-12kHz Line: 80Hz-12kHz Number of simultaneous use: 15 (15ch mode) / 10 (10ch mode) / 6 (when used with analog) Code setting: 10 pattern switching Battery life: Approximately 8 hours (transmitting output: H) at room temperature, continuous use Antenna: Built-in type Additional functions: Foldable built-in microphone (cannot be used when input 1 is connected to an external microphone) Built-in microphone ON/OFF switch (effective for built-in microphone) Volume down switch: Attenuation 20dB (effective for input 3, input 4) Display: Power/battery remaining display, input peak display, built-in microphone ON/OFF display, volume down display Operating temperature range: 0 ℃ - +40 ℃ Operating humidity range: 30% - 85% RH (no condensation) Finish: Top case: ABS resin, black (similar to Munsell N1.0) Bottom case: ABS resin, gray (similar to Munsell N6.0) Built-in microphone: Polyacetal resin, gray (similar to Munsell N6.0) Dimensions: 166 (W) x 69 (H) x 168 (D) mm (when microphone is stored, including protrusions) Weight: 520g Accessories: AC adapter...1, channel sticker (digital)...1, channel sticker (analog)...1, input display sticker...1, setting driver (built into main unit)...1, storage bag...1 (*1) 0 dB=1 V *Cannot communicate with TRANTEC digital wireless tuner S-D7802-JB-J. *Cannot communicate with analog wireless systems (WT-1822, WT-1824, etc., WTU-1830, etc.).