IMAGENICS / CRO-H26T

The CRO-H26T is a coaxial extender that, when combined with a receiver such as the CRO-H26R, enables the transmission of HDMI (DVI) signals up to 210m over a single coaxial cable. The transmission distance is independent of the resolution of the HDMI (DVI) signal and is compatible with both HDMI HDCP and DVI HDCP.

■HDMI signal coaxial extender/transmitter
■Input signal:
TMDS signal (digital RGB/YPbPr) HDMI-A connector x 1 (HDCP compatible, DVI signal input possible)
HDMI standard compliant signal (including embedded audio up to 8ch) or 24-bit full color DVI Rev1.0 standard compliant signal)
Simultaneously meets the following conditions: pixel clock 25 MHz to 165 MHz, horizontal frequency 15 kHz to 200 kHz, vertical frequency 23 Hz to 240 Hz, horizontal active pixels 320 to 2048, vertical active lines 240 to 1800 Automatically supports video signals up to 10 ... Method
■Output signal: Digital serial signal by original re-encoding method 1 system 1.0Vp-p 75Ω 2 distribution BNCx2
Bit rate after original re-encoding
Video: 2.592 Gbps (fixed bit rate)
Audio: 9.216 Mbps (fixed bit rate)
Original bidirectional communication link function
■HDCP standard: Supports HDCP for HDMI and HDCP for DVI
■RS-232C: RS-232C compliant full duplex D-Sub9 (male) 1 system
Switching between 9,600bps, 19,200bps, 38,400bps
Switching between non-flow (default value) and RTS/CTS hard flow
Switching between non-parity and even parity
■Coaxial transmission distance:
L-7CHD: 210m, L-5CFB: 110m, L-5C2V: 60m, L-3CFB: 60m, L-3C2V: 30m
(The distance may be shorter depending on the installation environment, etc.)

■EDID emulation function:
You can use the EDID data of the display device sent from the receiver through, or select from 15 types of built-in resolution data and use it with a DIP-SW.

You can also select DVI and HDMI signals at each resolution.

■Other functions:
LED display function for input signal status, HDCP status, and link status, various functions by cooperative processing with the receiver side, etc.

■Special notes:
Not compatible with HDMI signal CEC, ARC, HEAC functions, deep color, or high bit rate audio standards

■Notes:
When using this unit in combination with an IMG.Link switcher (ILS-41, ILS-1616, etc.) or a distributor (CRO-ID18A, etc.), please set the EDID setting of this unit to the built-in data (emulation function).

For details, please refer to the instruction manual of each device.

■Power supply: DC5V 0.6A
■Accessories:
1 AC100V 27VA 50 Hz/60Hz domestic AC adapter (5V 2.3A output)
1 HDMI connector retaining bracket (CL-1)
■SIZE: 100 (W) x 25 (H) x 150 (D) mm (excluding protrusions) 550g