TAMA / PMD1100M

This basic unit is ideal for setting up a standard five-piece kit. The vertical pipes are 850mm long, and the horizontal pipes for toms and other instruments are 1,100mm long with a radius. The ends of the vertical pipes are equipped with joints that can accommodate 19.1mm diameter cymbal holders. The pipe diameter is 38mm (excluding the leg pipes).

■ Drum Rack
■ Power Tower System
■ Basic Unit
■ Contents
Horizontal Pipe (1,100mm radius) x 1
Vertical Pipe (850mm radius) x 2 (with 19.1mm die-cast joint)
Leg Pipe (40mm width x 20mm height x 450mm length) x 2
Leg Joint Bracket (2.5mm hex wrench included) x 2
Leg Rubber x 4
Pipe Joint Bracket (J30TS) x 2
Pipe Holder (J34T) x 2
Memory Lock (A13S) x 4
Drum Hammer (DH7) x 1

○ Vertical Pipe
φ38mm stainless steel pipe. Grooves are provided at 50mm intervals. Using these as a guide, you can easily align the height of the horizontal pipes on both sides.
○ Horizontal Pipe
Rounded stainless steel pipe. By aligning the guideline attached to the center of the end of the horizontal pipe with the marker attached to the joint bracket (J30TS), you can align the angle of the tom-tom/cymbal holder when setting it on the horizontal pipe.

Memory Stickers
Includes stickers with numbers 1 to 10 and letters A to Z. By sticking them on the clamp or pipe connection points as markers, you can conveniently recreate the same setup when re-setting up.