Guitar remodeling course (wiring) Part 5

HELP
S Point

日本語

Sound House online course
Guitar lessons for beginners
Guitar remodeling course (wiring) Part 5

Switch to use

As before, it uses an on-on-on 6-pin mini switch where the switch stops in the middle and up and down

(※ Please pay attention to the number of contacts and the number of pins when purchasing a switch!)

How to wire series-tap-parallel changeover switch

First check the color of the wires coming out of each coil of the humbucking pickup.

All the wires from the pickup except for the bare earth wire are connected to the switch terminals.
Be careful when wiring because the lead wire crossing the center is connected to both the left center terminal and the right top terminal.

The lower left and right terminals of the right row are connected to the remaining lead wires from the pickup, and the lower left terminal is connected to the back of the pot, and the lower right terminal is connected to the third pot. It leads to the hot terminal.
It is difficult to connect two lead wires to a small terminal, but do your best!

What do you think?
With this wiring, you will get three variations of Series-Tap-Parallel! !

→ Guitar remodeling course (wiring) Part 1 "expansion of tap switch" and "expansion of direct switch"
→ Part 2 "expansion of series-parallel changeover switch"
→ Part 3 "wiring to output phase sound"
→ Part 4 "wiring to combine two wires of tap switch, phase sound change switch with one switch

Categories