在庫状況:Stock: 特別注文 Special Order 価格:¥92,800(税込)Price:92,800 yen(incl. tax)
参考になった人数:0人(0人中) 0 out of 0 people found this helpful.
(3.0)
hmmmm
2024/07/28
be simple: if you have a preamp with fully covered chassis (e.g. AudioScape 1290), think about it.
I only have 1 rack unit left so the solution is buying a single unit 500 power supplier. Radial one is out of stock so R53 became the answer. It fits perfectly with 500 units which comes without chassis, but encountered a huge issue on units with one.
1. slot 1 has a metal tip on the up left corner, so it’s physically impossible to insert and unit with chassis, the only way is trying slot 2 and 3 (at the end elysia mpressor was sitting on slot 1)
2. tried with slot 3, golden fingers position does not match. I have to bend the pcb board a little bit to fit
the problem is, signal flows from 1 to 3 (as far as what i tested), as from above I had to put my preamp on slot 3, so the link function is not working properly, cost another XLR cable.
beside of what described above, R53 works good.
R53 500シリーズ・ラックシャーシ
価格:¥92,800(税込) Price:92,800 yen(incl. tax)
I only have 1 rack unit left so the solution is buying a single unit 500 power supplier. Radial one is out of stock so R53 became the answer. It fits perfectly with 500 units which comes without chassis, but encountered a huge issue on units with one.
1. slot 1 has a metal tip on the up left corner, so it’s physically impossible to insert and unit with chassis, the only way is trying slot 2 and 3 (at the end elysia mpressor was sitting on slot 1)
2. tried with slot 3, golden fingers position does not match. I have to bend the pcb board a little bit to fit
the problem is, signal flows from 1 to 3 (as far as what i tested), as from above I had to put my preamp on slot 3, so the link function is not working properly, cost another XLR cable.
beside of what described above, R53 works good.